RT Snowmobile Ice Scratcher Universal Ski Mount Kit reversable from altimategear
RT-PRO Universal Ski Mount Kit reversable for TRAIL SKIIS See Application guide at bottom
Get snow where you need it and cool and lube your sled! Maintain constant pressure.
Made from Hardened Spring Steel Coated
Easily installed and stored!
Made in Canada!
Comes as a pair one for each ski
Did you know running a two stroke at 165 degrees is bad for it? Our customers are telling us the RT has dropped their temp by 30+-
A new revolutionary ice scratcher designed and developed by guys that ride. This kicks up SPRAY!
This product is spring loaded and the pressure is maintained over the life of the product!
Specification for The Spring scratcher with the Rubber U Yoke base: Resilient custom rubber support base is a proprietary composite formulated for -50C temperature operation and cycle tested for withstanding over 3 million 30 degree deflections
Spring steel scratcher “tine”-is a super durable long-lasting proprietary Rockwell hardness specification material Yoke base “U”and spring/bolt assembly designed specifically to function as an extreme impact absorbing unit.
Scratchers pressure set for ice. SEE IN OUR PHOTOS The higher the downward forceful pressure at the scratcher tip, the more lubricating ice chip spray is generated for the slider/track clips.
Maximized Slider Lubrication
Strong and Durable Very light Weight
Still plan to run cable scratchers….on your rails! Get 6 times the pressure from the RT !! Now !!
For all plastic trail skis in most cases the post will mount on inside surface of (a) rear outer ski rib on the inside surface of the outer rear ski rib (so the scratcher bracket/ wing itself stays over top of the ski protected from impacts.)
The only part of the scratcher that should protude over the inner edge of the ski should be the rod itself and no more than 1/3 of the rubber rod base.
List of Trail skis as follows:
Arctic Cat all standard Trail skis with four rear ribs(requires post to be mounted on the inside surface of the outer rear rib in between the two outer rear ribs by drilling the bolthole thru both outer rear ribs)
Polaris IQ ski
Ski-Doo Pilot 5.7 & 5.9 model in both widths.
SkiDoo Precision ski (post mounts on front of metal saddle or on inside of outer front or rear plastic rib when plastic material is removed with a hand drill bit down beside rib to accommodate bottom of post and bolt nut .)
Yamaha skis including
Tuner ski and
Tuner 3 and all previous older standard plastic Yamaha Trail skis.
C&A pro race/ trail skis-all
USI skis- all- post mounts on front of metal ski saddles.
Curve trail skis -all
Slydog Trail ski-all
kimpex Arrow Trail ski
For the Polaris Pro steer Skiis the proper application is to use the MTN-RT Scratcher For the SKi doo TS ski see TS-Ski-RT Scratcher
All mountain skiis require the MTN-RT with exception the SLP Mohawk cannot be fitted